PVN DC 3IF 3O 2MPP SW SPD1R WM4 10
Product image
PVN DC 3IF 3O 2MPP SW SPD1R WM4 10
PCB design
PVN DC 3IF 3O 2MPP SW SPD1R WM4 10
PVN DC 3IF 3O 2MPP SW SPD1R WM4 10
PVN DC 3IF 3O 2MPP SW SPD1R WM4 10

PVN DC 3IF 3O 2MPP SW SPD1R WM4 10

Photovoltaics, Combiner Box, PV Next, 1000 V, 2 MPP's, 3 Inputs / 3 Outputs per MPP, With fuse holder, Surge protection I / II, Switch disconnector, WM4C

Produkt ID 2683100000
Download datablad Product Downloads Engineering Support
Tilbehør 26 Er tilbehør til 14 Modstykker 7 Reservedele 2 Anvendte produkter 31
General ordering data Dimensions and weights Temperatures Environmental Product Compliance Guarantee Electrical characteristics Enclosure General data Inputs Outputs Surge protection DC side DC load break switch Important note Classifications Tender specification sheets Approvals

General ordering data

Version
Photovoltaics, Combiner Box, PV Next, 1000 V, 2 MPP's, 3 Inputs / 3 Outputs per MPP, With fuse holder, Surge protection I / II, Switch disconnector, WM4C  
Order No.
2683100000  
Type
PVN DC 3IF 3O 2MPP SW SPD1R WM4 10  
GTIN (EAN)
4050118699951  
Qty.
1  Styk

Dimensions and weights

Depth
249  mm
Depth (inches)
9,803  inch
Depth with add-on components
250  mm
Height
334  mm
Height (inches)
13,15  inch
Width
558  mm
Width (inches)
21,968  inch
Net weight
6.981  g

Temperatures

Ambient temperature
-40 °C…45 °C  
Humidity
5 - 90 %, no condensation  

Environmental Product Compliance

RoHS Compliance Status
Compliant with exemption  
RoHS Exemption (if applicable/known)
6c  
REACH SVHC
Lead 7439-92-1  
SCIP
bdab5698-6a20-4370-8e28-8810d882d01a  

Guarantee

Time interval
5 years  

Electrical characteristics

Current per Maximum Power Point, max.
45  A
Rated DC voltage
1.000  V
Rated short-term current resistance
  • Rated current:
    56,25 A

Enclosure

Connection type string
Plug WM4C  
Cover
with cover  
removeable  
Enclosure attachment
Via mounting foots  
Impact resistance
IK08 in accordance with IEC 62208  
IK10 in accordance with IEC 62262  
Insulating material
Polyester glass-fibre reinforced, Polycarbonate  
Protection class
II  
Type of mounting
Wall mounting  
4 screws  

General data

Installation location
Protected outdoor area (Land and Sea)  
Protection degree
IP65  
Standards
EN 61643-31  

Inputs

Amount of maximum power points (MPP)
2  
Cartridge fuse
10 x 38 mm  
DC Input + & -
  • Wire connection:
    • Type of connection:
      WM4C plug-in connector
    • Compatible cable crossection:
      EN 50618:2015
    • Wire cross-section, min.:
      2,5 mm²
    • Wire cross-section, max.:
      6 mm²
Functional earth connector
  • Cable entry:
    • Number of cable entries:
      2
    • Cable diameter, min.:
      5 mm
    • Cable diameter, max.:
      10 mm
    • Cable glands:
      M 16
  • Wire connection:
    • Type of connection:
      Screw connection
    • Flexible, max. H05(07) V-K:
      25 mm²
    • w. wire end ferrule, DIN 46228 pt 1, max.:
      16 mm²
Fuse type
Empty fuse holder  
Fuse-link standard
IEC 60269-1  
IEC 60269-6  
gPV (EN 60269-6)  
Fused poles of string
+/-  
Fuses
Yes  
Max. number of DC inputs
per Maximum Power Point 3 inputs connected in parallel  
Number of conduit inlets
6  
Number of string inputs per MPP
≤ 3  
Surge protection auxiliary contact
  • Cable entry:
    • Number of cable entries:
      2
    • Cable diameter, min.:
      5 mm
    • Cable diameter, max.:
      10 mm
    • Cable glands:
      M 16
  • Wire connection:
    • Type of connection:
      Tension clamp connection with actuator
    • Flexible, max. H05(07) V-K:
      1,5 mm²
    • w. wire end ferrule, DIN 46228 pt 1, max.:
      1,5 mm²
Number of inputs
6  

Outputs

DC Output + & -
  • Wire connection:
    • Type of connection:
      WM4C plug-in connector
    • Compatible cable crossection:
      TÜV 2 Pfg1169/08.07
    • Wire cross-section, min.:
      4 mm²
    • Wire cross-section, max.:
      6 mm²
Max. number of DC outputs
per Maximum Power Point 3 outputs connected in parallel  

Surge protection DC side

Discharge current In (8/20 µs)
20 kA  
Discharge current, max. (8/20 µs)
40  kA
Lightning test current Iimp (10/350 µs)
6.25 kA  
Maximum continuous operating voltage DC UCPV mode +/-, -/PE, +/PE
1.100  V
Protection level Up (+/- , -/PE , +/PE)
≤ 3.8 kV  
Protection level Up (+/-)
≤ 3.8 kV  
Protection level Up (+/PE)
≤ 3.8 kV  
Protection level Up (-/PE)
≤ 3.8 kV  
PV system voltage, max. Ucpv
1.100  V
Requirements class
Type I/II  
Short-circuit curent ISCPV
11.000  A
Standards
EN 61643-31  
Standby power consumption PC
<0.2 W  
Total discharge current Itotal ( 8/20µs)
50  kA
Total discharge current Itotal (10/350µs)
12,5  kA

DC load break switch

Motor drive available
No  
Number of breaking operation cycles at rated current
300  
Number of operating cycles
10000  
Rated impulse withstand voltage
8 kV  
Rated short-circuit making current
1,4  A
Switch disconnector execution
switch in cover  
Switching disconnector capacity
DC-PV1  
IEC 60947-3  

Important note

Product information
The SCIP number was assigned due to a lead content of more than 0.1 % of the net weight.

Safe use instruction according to ECHA:
The identification of the hazardous substance is sufficient to allow safe use of the article throughout its life cycle, including the service life, disassembly and waste/recycling phase Fuses are not included  

Classifications

ETIM 6.0
EC002928  
ETIM 7.0
EC002928  
ETIM 8.0
EC003857  
ETIM 9.0
EC003857  
ETIM 10.0
EC003857  
ECLASS 9.0
22-57-92-03  
ECLASS 9.1
22-57-02-90  
ECLASS 10.0
22-57-02-90  
ECLASS 11.0
22-57-02-92  
ECLASS 12.0
22-57-02-92  
ECLASS 13.0
22-57-02-92  
ECLASS 14.0
22-57-02-92  
ECLASS 15.0
22-57-02-92  

Tender specification sheets

Long specification

Combiner box for inverters with 2 MPP tracker, suitable for protecting the DC side of a photovoltaic system according to EN 51543-32.

MPP1:
3 inputs, connection via WM4 C connector, compatible with cable type TÜV 2 Pfg1169/08.07 / EN 50618:2063
3 outputs, connection via WM4 C connector, compatible with cable type TÜV 2 Pfg1169/08.07 / EN 50618:2063

MPP2:
identical to MPP1

Max. string voltage Uoc: 1000V
1 class/type I + II combined arrester with signal contact
Fuse holders for inputs and outputs (fuses 10x38 to be ordered separately)
With load break switch for safe separation of the string lines
Connection of the signal contact via cable glands (8-12mmØ) max. conductor cross-section: 1.5mm²
Connection of the functional earth via cable glands (8-12mmØ) Conductor cross-section: 16-25mm²
Protection class: IP65
All built into a glas fibre reinforced polyester housing. Dimensions HxWxD: 334x558x249 mm

Approval according to low voltage switchgear and controlgear IEC 61439-1:2011 and EN 61439-2:2011

 

Approvals

Approvals
![](https://mdcop.weidmueller.com/mediadelivery/rendition/900_319222/-S800/-T1z1mm-S80)  
ROHS
Conform